Epp SV4 second flight session after adjustments
The second flight session of my SV4 epp of 85 cm (31 inches). I have modified the position of the landing gear, the center of gravity, and the aileron system…
The second flight session of my SV4 epp of 85 cm (31 inches). I have modified the position of the landing gear, the center of gravity, and the aileron system…
The 3 planes of the day in the car and ready to fly Finally the first flights on video https://youtu.be/7w7jNSNIxqs
I made the landing gear with a carbon rod glued to the structure. A bent iron rod was glued to the carbon rod and held with a piece of heat-shrinkable…
The assembly of the SV4 stampe in 85 cm epp is advancing and almost nearing its end. To start, I cut the location of the aileron servos which were then…
The assembly of the stampe continues with the installation of hinges on the control surfaces of ailerons. I use mini hinges which I find top for planes of this scale.…
I used 1mm carbon rods to strengthen the fuselage and make it more rigid. Bonding of the fixed part of the elevator and installation of carbon rods to maintain the…
The stampe consists of 2 wings cut in one piece each, the ruder and the rudder flap, as well as the elevator and its flaps. The fuselage consists of 3…
Yes the decoration is very important. The desire to build airplanes is the realization of a dream that we have by admiring the real one. No exception to this rule…
Hello A new project of indoor plane, which is following my mini SV4. The latter is flying quite well, but a little too fast. I wanted to built a new…